Anafrog

si quelqu'un est tenté par la réalisation de la reverb à partir d'une cymbale qu'il me contacte, je peux fournir une cymbale et m'occuper de la partie menuiserie en échange de la partie électronique.

En fait ce n'est pas loin du principe du diffuseur 3 (Gong) des Ondes Martenot

Thanks for the positive reaction [ and the entries at the anafrog site]

O.k...my cymbal /plate reverb.........
There are 2 small loudspeakers on the surface.
One is driven by cheap computer audio amplifier [logitech] via the send on my mixer and the other speaker or microphone goes to the mic in [send/return]on my mixer.
You can also use a normal audio amp for that.
Thats all :)
No fancy schematics.

Also remember..if you make a cymbal reverb, do not heaten the cymbal with a fire burner or soldering gun.
The tension of the cymbag get broken by that...and you can hear that by lesser reverb.

greets Peter

peut être même plus économique

hello cyril

Jeps, you got it.
The speakers are glued on the cymbal.
Eehhmm..... i think i used bizon kit transparant :)
Look at the construction of the big plate reverbs for a eventually better solution .
I used for my cymbal small speakers , but you can experiment also with bigger ones for the drive [after the amp]
For the mic out ,you can also use small electret or dynamic contact microphones.
Acousic guitar contacts microphones or field mics.

Thats it .
Now i go further this weekend to develop a simple and easy to make tube filter, driven by 9 to 12 volts.
Like my easy diy filter.

Friendly greetings from the netherlands
peter, Aka Hilltree _ Dutch synthforum Moderator