voici le retour de michael barton, j'ai pas tout compris malgré google traduction, le résultat reste étrange:
and sorry for my english
ma question:
Hi, its cyril from france
i have a problem with the outputs module
the 10 ohms v+ smoke systematically, i think the module in powered by the right way, (v- = red line just to be sure!!!!)
do you have an idea? do you already have the same problem? no problem with the midi 2 trig/gate....and others modules
cheers
cereale
sa réponse:
Hi Cyril,
I think you may have plugged it in backwards. It looks like Eagle
swapped the +v and -v on my part for the MOTM connector, and so it's
displaying it backwards. The screenprinting on the PCB shows which way
to plug in the connecter, there is a mark on the side of the the
connecter where the tab should go. To be specific, the tab should be
pointing away from the center of the PCB and the red line should be
lined up with the MOTM pad marked "V+"
Sorry for the confusion, but if this was the only problem, then it will
only have damaged the 10 ohm resistors and everything else will be ok.
-Michael
si ça peut vous aider ou pas, et confirmer ou non les précédents échanges
si je comprends bien mais ça m'étonne il faut aligner la ligne rouge du câble sur le + ?????????
voilà, bon réveil